Section 43 (Audio/Video/Entertainment/Connectivity (Service Information) 500 - Electric): Radio: Installation

Courtesy of CHRYSLER GROUP, LLC

1. While installing the radio (1), connect the electrical connectors.
2. Install and tighten the four radio to instrument panel screws (2).

   Courtesy of CHRYSLER GROUP, LLC

3. Position the radio bezel (1) onto the instrument panel.
4. Install and tighten the four radio bezel to instrument panel screws.
5. Connect the 12-volt negative battery cable.
6. Power up the high-voltage system. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .

NOTE:

The radio must be programmed after a radio replacement. Refer to MODULE, RADIO RECEIVER, MODULE PROGRAMMING .