LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 41 (Heating & Air Conditioning (Service Information) 500 - Electric) >> Controls >> Transducer, A/C Pressure >> Removal

Transducer, A/C Pressure: Removal

WARNING: This page is about a different variant/trim than selected.
WARNING:

On vehicles equipped with the high voltage system, disconnecting the 12 volt battery negative cable alone will not power down the 12 volt system. You must perform the 12 volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

NOTE:

It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.

  1. Disconnect and isolate the 12 volt negative battery cable.
  2. Power down the high-voltage system. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
    GC0152396Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connector (1) from the A/C pressure transducer (2), located on the A/C liquid line (3).
  4. Remove the A/C pressure transducer from the A/C liquid line.
    GC0152397Courtesy of CHRYSLER GROUP, LLC
  5. Remove and discard the O-ring seal (1), located on the A/C liquid line fitting (2).
scientia non olet · About LEMON Manuals