LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 41 (Heating & Air Conditioning (Service Information) 500 - Electric) >> Controls >> Control, A/C And Heater >> Installation >> Automatic Temperature Control (ATC)

Automatic Temperature Control (ATC)

WARNING: This page is about a different variant/trim than selected.
GC0152866Courtesy of CHRYSLER GROUP, LLC
  1. Position the A/C heater control (1) to the instrument panel and connect the Heating, Ventilation and Air Conditioning (HVAC) wire harness connector (2).
    GC0152865Courtesy of CHRYSLER GROUP, LLC
  2. Install the instrument panel cover. Refer to INSTALLATION .
  3. Install the four screws (2, 3, 5 and 6) that secure the A/C heater control (1) to the instrument panel cover (4). Tighten the screws securely.
  4. Install the instrument panel center bezel. Refer to INSTALLATION .
    GC0152863Courtesy of CHRYSLER GROUP, LLC
  5. Position the control panel (3) to the instrument panel and connect the HVAC wire harness connector (2) to the accessory switch pod (1).
    GC0153288Courtesy of CHRYSLER GROUP, LLC
  6. Position the control panel (1) to the instrument panel (2) and engage the retaining tabs that secure the panel to the A/C heater control. Make sure the retaining tabs are fully engaged.
  7. Connect the 12 volt negative battery cable.
  8. Power up the high voltage system Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
  9. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals