Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
CHECK THE (F342) FUSED ASD RELAY OUTPUT CIRCUIT FOR AN OPEN
1. Turn the ignition off.
2. Disconnect the Fuel Injector 4 harness connector.
3. Turn the ignition on, engine not running.
4. With the scan tool, actuate the Auto Shutdown (ASD) Relay Control State.
5. Using a 12-volt test light connected to ground, check the (F342) Fused ASD Relay Output circuit in the Fuel Injector 4 harness connector.
  NOTE:
  The test light should be illuminated and bright. Compare the brightness to that of a direct connection to the battery.
  
  Is the test light illuminated and bright?
  
  Yes
  - Go To 3
  No
  - Repair the (F342) Fused ASD Relay Output circuit for an open.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
CHECK THE (K14) FUEL INJECTOR 4 SIGNAL CIRCUIT FOR A SHORT TO GROUND
1. Turn the ignition off.
2. Disconnect the PCM C2 harness connector.
3. Check for continuity of the (K14) Fuel Injector 4 Signal circuit between ground and the Fuel Injector 4 harness connector.
  Is there continuity of the (K14) Fuel Injector 4 Signal circuit?
  
  Yes
  - Repair the (K14) Fuel Injector 4 Signal circuit for a short to ground.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Go To 4
CHECK THE FUEL INJECTOR 4 CIRCUIT RESISTANCE
1. Measure the resistance of Fuel Injector 4.
  NOTE:
  The resistance of the Fuel Injector will vary according to the temperature of the injector coil.
  
  Is the resistance of the Fuel Injector between 9.0 and 18.0 ohms?
  
  Yes
  - Go To 5
  No
  - Replace Fuel Injector 4 in accordance with the service information. Refer to INJECTOR(S), FUEL, REMOVAL .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
POWERTRAIN CONTROL MODULE (PCM)
1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the Fuel Injector 4 and the Powertrain Control Module.
2. Look for any chafed, pierced, pinched, or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals.
4. Perform any Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Replace and program the Powertrain Control Module (PCM) in accordance with the service information. Refer to MODULE, POWERTRAIN CONTROL (PCM), REMOVAL .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .