LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (1.4L 16-Valve Turbo Engine (Service Information) - 500) >> Turbocharger System >> Cooler And Hoses, Charge Air >> Installation

Cooler And Hoses, Charge Air: Installation

WARNING: This page is about a different variant/trim than selected.
GC0153800Courtesy of CHRYSLER GROUP, LLC
  1. Set the left cooler (3) and hose into position with the duct (1) installed.
  2. Install the bracket bolt (2).
  3. Tighten bolt to 18 N.m (13 ft. lbs.).
    GC0153799Courtesy of CHRYSLER GROUP, LLC
  4. Set the right cooler (3) and hose assembly into position with the duct (2) installed.
  5. Install the bracket bolt (1).
  6. Tighten the bolt to 18 N.m (13 ft. lbs.).
    GC0153798Courtesy of CHRYSLER GROUP, LLC
  7. Snap the left hose quick connect onto the tube (1). Pull back on the hose end of the connector to ensure the connections are fully seated.
    GC0153797Courtesy of CHRYSLER GROUP, LLC
  8. Snap the right hose quick connect onto the tube (1). Pull back on the hose end of the connector to ensure the connections are fully seated.
    GC0153632Courtesy of CHRYSLER GROUP, LLC
  9. Install the front bumper fascia. Refer to FASCIA, FRONT, INSTALLATION .
scientia non olet · About LEMON Manuals