Switch, Oil Pressure: Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
The oil pressure switch has a lock patch on the threads and if removed can not be reinstalled.
- Install a new oil pressure switch (2) and tighten to 32 N.m (24 ft. lbs.).
- Connect the oil pressure switch electrical connector (1).
- Install the frame splash shield (3) and the three screws (1).
- Install the front wheelhouse splash shield and the two screws (2).
- Install the right vertical brace (5) and the two bolts (4).
- Lower the vehicle.
- Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).