LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (1.4L 16-Valve Turbo Engine (Service Information) - 500) >> Engine Mounting >> Bracket, Engine Mount, Right >> Installation

Bracket, Engine Mount, Right: Installation

WARNING: This page is about a different variant/trim than selected.
GC0152463Courtesy of CHRYSLER GROUP, LLC
  1. Install the right engine mount bracket (1) with six bolts (2) tightened to 25 N.m (18 ft. lbs.).
    GC0152466Courtesy of CHRYSLER GROUP, LLC
  2. Install the upper timing belt cover (1) with two bolts (2 and 3) tightened to 9 N.m (80 in. lbs.).
    GC0155975Courtesy of CHRYSLER GROUP, LLC
  3. Engage the following retainers to the upper timing belt cover (1):
    • Wastegate solenoid pressure inlet hose (2).
    • After run coolant pump return hose (3).
    • Evaporative emissions purge hose (4).
    GC0156333Courtesy of CHRYSLER GROUP, LLC
  4. Position the turbocharger wastegate solenoid (4). Install the bolt (5) and tighten to 9 N.m (80 in. lbs.).
    GC0153367Courtesy of CHRYSLER GROUP, LLC
  5. Install the right engine mount isolator (3) to the engine mount bracket with three bolts. Tighten the isolator to engine bracket bolts in the sequence shown in illustration to 60 N.m (44 ft. lbs.).
  6. Install the right engine mount isolator (3) to the body with three bolts (2). Tighten the isolator to body bolts (2) to 60 N.m (44 ft. lbs.).
  7. Remove the floor jack supporting the engine.
    GC0156417Courtesy of CHRYSLER GROUP, LLC
  8. Install the pressurized coolant bottle

    Refer to BOTTLE, PRESSURIZED COOLANT, INSTALLATION .

  9. Install the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION .
  10. Connect the battery negative cable and tighten nut to 5 N.m (45 in. lbs.).
  11. Install the belly pan. Refer to BELLY PAN, INSTALLATION .
scientia non olet · About LEMON Manuals