LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (1.4L 16-Valve Turbo Engine (Service Information) - 500) >> Engine Block >> Seal, Crankshaft Oil, Rear >> Removal >> With Manual Transmission

With Manual Transmission

WARNING: This page is about a different variant/trim than selected.
GC0082359Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING .
  3. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  4. Drain the engine oil. Refer to STANDARD PROCEDURE - ENGINE OIL AND FILTER CHANGE  .
    GC0156315Courtesy of CHRYSLER GROUP, LLC
  5. Remove the manual transmission from the vehicle. Refer to REMOVAL .
    GC0156336Courtesy of CHRYSLER GROUP, LLC
  6. Remove the two bolts (1) and the flywheel dust covers (2 and 3).
    GC0155963Courtesy of CHRYSLER GROUP, LLC
  7. Remove the clutch and flywheel. Refer to FLYWHEEL, REMOVAL .
    GC0152688Courtesy of CHRYSLER GROUP, LLC
  8. Remove fourteen bolts (1), two nuts and two studs (2) from the flange of the oil pan.
  9. Using the four indicated pry points, carefully remove the oil pan.
    GC0168968Courtesy of CHRYSLER GROUP, LLC
  10. Remove the tone wheel (1) from the crankshaft.
    GC0168974Courtesy of CHRYSLER GROUP, LLC
  11. Loosen the crankshaft position sensor mounting screw (3) just enough to remove and reposition the Crankshaft Position Sensor (CKP).
    NOTE:

    The screw (3) has a captured washer and does not need to be removed from the CKP sensor.

  12. Remove the six seal retainer attaching screws (1).
  13. Remove and discard the seal retainer (2).
    GC0152689Courtesy of CHRYSLER GROUP, LLC
  14. Remove all residual sealant (1) from the oil pan, engine block and oil pump. Refer to PAN, OIL, CLEANING .
scientia non olet · About LEMON Manuals