LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (1.4L 16-Valve Turbo Engine (Service Information) - 500) >> Engine Block >> Seal, Crankshaft Oil, Rear >> Removal >> With Automatic Transmission

With Automatic Transmission

WARNING: This page is about a different variant/trim than selected.
GC0152420Courtesy of CHRYSLER GROUP, LLC
  1. Remove the engine and transmission from the vehicle. Refer to REMOVAL .
    GC0153134Courtesy of CHRYSLER GROUP, LLC
  2. Remove the starter assembly (5). Refer to STARTER, REMOVAL .
    GC0168976Courtesy of CHRYSLER GROUP, LLC
  3. Remove the transmission and flexplate (1) from the engine. Refer to FLEXPLATE, REMOVAL .
    GC0152425Courtesy of CHRYSLER GROUP, LLC
  4. Remove three bolts (3 and 4), one bolt and nut (2) and the transmission adapter plate (1).
    GC0152688Courtesy of CHRYSLER GROUP, LLC
  5. Drain the engine oil. Refer to STANDARD PROCEDURE - ENGINE OIL AND FILTER CHANGE  .
  6. Remove fourteen bolts (1), two nuts and two studs (2) from the flange of the oil pan.
  7. Using the four indicated pry points, carefully remove the oil pan.
    GC0168968Courtesy of CHRYSLER GROUP, LLC
  8. Remove the tone wheel (1) from the crankshaft.
    GC0168974Courtesy of CHRYSLER GROUP, LLC
  9. Loosen the crankshaft position sensor mounting screw (3) just enough to remove and reposition the Crankshaft Position Sensor (CKP).
    NOTE:

    The screw (3) has a captured washer and does not need to be removed from the CKP sensor.

  10. Remove the six seal retainer attaching screws (1).
  11. Remove and discard the seal retainer (2).
    GC0152689Courtesy of CHRYSLER GROUP, LLC
  12. Remove all residual sealant (1) from the oil pan, engine block and oil pump. Refer to PAN, OIL, CLEANING .
scientia non olet · About LEMON Manuals