Tube, Spark Plug: Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
The spark plug tube is pre-treated with sealant (1), therefore it must be replaced each time it is removed. Do not add any additional sealant to the threads.
- Position the spark plug tube (2) into the cylinder head. Using the (special tool #10280, Remover/Installer, Spark Plug Tube) (1), tighten the tube to 41 N.m (30 ft. lbs.).
- If required, install a new spark plug tube seal (1).
- Install the cylinder head cover. Refer to COVER(S), CYLINDER HEAD, INSTALLATION .
Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).