LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (1.4L 16-Valve Turbo Engine (Service Information) - 500) >> Cylinder Head >> Spring(S), Valve >> Removal >> Off Vehicle

Off Vehicle

WARNING: This page is about a different variant/trim than selected.
GC0144220Courtesy of CHRYSLER GROUP, LLC
  1. Remove the cylinder head. Refer to CYLINDER HEAD, REMOVAL .
  2. Position the (special tool #10224, Adapter, Valve Spring) (2) in the (special tool #C-3422-D, Compressor, Valve Spring) (1).
    GC0152626Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Number 3 cylinder exhaust valve spring compression shown, all other valves similar.

  3. Compress the valve spring (4) and remove the valve retaining locks (3).
    GC0152622Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    If the springs are to be reused, identify their positions so that they can be reassembled into their original locations. Number 2 cylinder exhaust valve spring shown, all other valves similar.

  4. Release the valve spring compression and remove the valve spring retainer (1) and valve spring (2).
  5. If required, remove the valve(s). Refer to VALVES, INTAKE AND EXHAUST, REMOVAL .
  6. If required, remove the valve guide seal and spring seat. Refer to SEAL(S), VALVE GUIDE, REMOVAL .
scientia non olet · About LEMON Manuals