LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (1.4L 16-Valve Turbo Engine (Service Information) - 500) >> Cylinder Head >> Lifter(S), Hydraulic >> Installation

Lifter(S), Hydraulic: Installation

WARNING: This page is about a different variant/trim than selected.
GC0152612Courtesy of CHRYSLER GROUP, LLC
NOTE:

If the hydraulic lifters are being reused, reassemble them into their original locations.

  1. Verify that the hydraulic lifters are at least partially full of oil. There should be little or no plunger travel when the hydraulic lifter is depressed.
  2. Install the hydraulic lifter(s) (1).
  3. Install the camshaft(s). Refer to CAMSHAFT, ENGINE, INSTALLATION .
  4. Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).
scientia non olet · About LEMON Manuals