Daytime Running Lamps

WARNING: This page is about a different variant/trim than selected.

NOTE:

Before performing the following tests, determine whether the clearance (also known as position or park) lamps operate. If the clearance lamps are also ineffective, diagnose and repair that problem before attempting to repair the Daytime Running Lamps.

CONDITION	POSSIBLE CAUSES	CORRECTION
DAYTIME RUNNING LAMPS WILL NOT ILLUMINATE	1. Incorrect BCM programming.	1. Use the IPC to check and configure BCM if required.
	2. Automatic transmission in PARK position.	2. Place the transmission gear selector lever in any position except PARK.
	3. Parking brake applied.	3. Release the parking brake.
	4. Engine not running.	4. Start the engine.
	5. Ineffective BCM inputs or outputs.	5. Use a diagnostic scan tool to test the BCM inputs and outputs. Refer to the appropriate diagnostic information.