Lever, Parking Brake: Installation
WARNING: This page is about a different variant/trim than selected.
- Place the parking brake lever (6) on the floor pan and install mounting bolts (2). Tighten the bolts to 30 Nm (22 lbf-ft).
- Install the rear parking brake cables into the equalizer (3) on the parking brake lever output cable.
- Connect the wiring harness connector (2) to the parking brake switch (6).
- Perform parking brake adjustment procedure.
- Install the center floor console. Refer to INSTALLATION .
- Remove the blocks from the tires and wheel assemblies.
- Power up the vehicle Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
- Connect the battery negative cable to its post on the battery.