LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Base Brakes (Service Information) - 500 - Electric) >> Hydraulic/Mechanical >> Tubes And Hoses, Brake >> Removal >> Rear Flexible Hose

Rear Flexible Hose

WARNING: This page is about a different variant/trim than selected.
  1. Install prop rod on the brake pedal to keep pressure on the brake system. Holding pedal in this position will isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the area of repair instead of the entire system.
    GC0153698Courtesy of CHRYSLER GROUP, LLC
  2. Raise and support the vehicle. Refer to HOISTING .
  3. Remove the tire and wheel assembly.
  4. Remove the solid brake line fitting (3).
  5. Remove the retaining clip (2) securing the flexible brake hose (1) to the mounting bracket.
    GC0153699Courtesy of CHRYSLER GROUP, LLC
  6. Remove the flexible brake hose (2) from the front bracket.
  7. Remove the brake hose fitting (1) from the caliper and remove the brake hose from the vehicle.
scientia non olet · About LEMON Manuals