Hub And Bearing: Installation
WARNING: This page is about a different variant/trim than selected.
- Slide the hub and bearing (4) onto the spindle (5).
- Install a washer (2) and a NEW hub nut (1) on the spindle. Tighten the nut to 280 Nm (207 lbf-ft).
- Install the brake rotor (3) and caliper assembly (6). Install and tighten the caliper adapter mounting bolts (7) to 57 Nm (42 lbf-ft). Refer to ROTOR, BRAKE, INSTALLATION
.
- Install the hub and bearing dust cap (2).
- Install rotor mounting pins (1) and tighten to 12 Nm (106 lbf-in).
- Install tire and wheel assembly. Refer to INSTALLATION .
- Lower the vehicle.
- Pump the brake pedal several times to ensure the vehicle has a firm brake pedal before moving the vehicle.