Charging (Service Information) - 500: Generator: Removal

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the negative battery cable.
2. Remove the accessory drive belt (4).

   Refer to BELT, SERPENTINE, REMOVAL .

3. Support and raise the vehicle.

   Refer to HOISTING .

   Courtesy of CHRYSLER GROUP, LLC

4. Remove the belly pan (1)

   Refer to BELLY PAN, REMOVAL .

   Courtesy of CHRYSLER GROUP, LLC

5. Remove the right side axle shaft and intermediate shaft

   Refer to REMOVAL .

   Courtesy of CHRYSLER GROUP, LLC

6. Disconnect the generator field wire harness connector.
7. Remove nut and the B+ cable from the generator stud.
8. Remove the top generator mounting bolt (1). This bolt is located between the generator and the A/C compressor.
9. Remove the bottom two generator mounting bolts (2) and the generator (3).