Charging (Service Information) - 500: Generator: Installation

Courtesy of CHRYSLER GROUP, LLC

1. Carefully position the generator (3) up to the engine block and loosely install the bottom two generator mounting bolts (2).
2. Install the top generator mounting bolts (1).
3. Tighten the generator mounting bolts to 25 Nm (18 lbf-ft).
4. Install the generator B+ cable on the generator stud. Tighten nut to 4 Nm (36 lbf-in).
5. Connect the field generator harness connector.

   Courtesy of CHRYSLER GROUP, LLC

6. Install the intermediate shaft and right side axle shaft

   Refer to INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

7. Install the belly pan (1)

   Refer to BELLY PAN, INSTALLATION .

8. Lower the vehicle.

   Courtesy of CHRYSLER GROUP, LLC

9. Install the accessory drive belt (4)

   Refer to BELT, SERPENTINE, INSTALLATION .

10. Connect the negative battery cable and tighten nut to 5 Nm (45 lbf-in).
11. Start the engine and verify the generator is operating properly.