LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 E >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Base Brakes (Service Information) - 500 - Except Electric) >> Parking Brake >> Lever, Parking Brake >> Removal

Lever, Parking Brake: Removal

WARNING: This page is about a different variant/trim than selected.
GC0152743Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Block the tire and wheel assemblies so the vehicle does not move once the vehicle parking brake lever is released.
  3. Remove the floor console. Refer to CONSOLE, FLOOR, REMOVAL .
  4. Position parking brake boot (1) so that the mounting bolts and switch can be accessed.
  5. Release and lower the parking brake lever (5).
  6. Loosen the adjusting nut (4) on the equalizer and disconnect the brake actuation cables from the equalizer.
  7. Disconnect the wiring harness connector (6) from the parking brake switch.
  8. Remove the bolts (2) attaching the parking brake lever (5) to the vehicle.
  9. Remove the parking brake lever (5).
scientia non olet · About LEMON Manuals