Reinforcement, Bumper, Front: Installation

Courtesy of CHRYSLER GROUP, LLC

1. Position the lower bumper reinforcement (2) to the frame/front end module.
2. Install the fasteners securing the lower bumper reinforcement (2) to the frame/front end module. Tighten the fasteners to 45 Nm (33 lbf-ft). If necessary, repeat on the opposite side.
3. Position the upper bumper reinforcement (1) to the frame/front end module.
4. Install the fasteners securing the upper bumper reinforcement (1) to the frame/front end module. Tighten the fasteners to 45 Nm (33 lbf-ft). If necessary, repeat on the opposite side.
5. Install the front fascia. Refer to INSTALLATION  .