Horn System (Service Information) 500 - Electric: Horn: Removal
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- Perform the 12 Volt Power Down procedure. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
- Remove the splash shield from the left front wheel house. Refer to REMOVAL .
- Disconnect the wire harness electrical connector (2) from the horn (3).
- Remove the screw (1) that secures the horn bracket to the left outboard end of the Front End Module (FEM) carrier.
- Remove the horn and bracket as a unit from the FEM carrier.