Switch, Oil Pressure: Installation: Installation

Fig 1: Oil Pressure Switch & Connector

Courtesy of CHRYSLER GROUP, LLC

NOTE:

The oil pressure switch has a lock patch on the threads and if removed can not be reinstalled.

Install a new oil pressure switch (2) and tighten to 32 N.m (24 ft. lbs.).
Connect the oil pressure switch electrical connector (1).

Fig 2: Right Vertical Brace, Frame Splash Shield & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Install the frame splash shield (3) and the three screws (1).
Install the front wheelhouse splash shield and the two screws (2).
Install the right vertical brace (5) and the two bolts (4).
Lower the vehicle.
Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).