Shaft, Output: Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.

Install the rear bearing race to the shaft using the Bearing Splitter (special tool #P-334, Splitter, Bearing).

Fig 1: Needle Bearing
Courtesy of CHRYSLER GROUP, LLC
Install needle bearing (1).

Fig 2: Installing First & Second Gear Synchronizer Hub Assembly
Courtesy of CHRYSLER GROUP, LLC
Install the first and second gear synchronizer hub assembly using (special tool #C-3095-A, Installer, Bearing).

Fig 3: Removing/Installing Snap Ring
Courtesy of CHRYSLER GROUP, LLC
Install the snap ring.

Fig 4: Needle Bearing
Courtesy of CHRYSLER GROUP, LLC
Install the needle bearing.

Fig 5: Installing Second/Third Driven Gears, Third Gear Spacer & Fourth Driven Gear
Courtesy of CHRYSLER GROUP, LLC
Install the second/third driven gears, third gear spacer and the fourth driven gear to the main shaft.

Fig 6: Pressing Gears Into Place
Courtesy of CHRYSLER GROUP, LLC
Using Bearing Installer (special tool #L-4507, Installer, Bearing) (1), press the gears into place.

Fig 7: Installing New Rear Bearing
Courtesy of CHRYSLER GROUP, LLC
Using (special tool #L-4507, Installer, Bearing) (1) install the new rear bearing (3) into place, install the new snap ring to the bearing.