Input Shaft, Transmission: Disassembly: Disassembly

WARNING: This page is about a different variant/trim than selected.

Fig 1: Removing Front Input Shaft Front Bearing

Courtesy of CHRYSLER GROUP, LLC

Remove the front input shaft front bearing using (special tool #P-334, Splitter, Bearing).

Fig 2: Removing Rear Input Shaft Rear Bearing, Spacer & Collar
Courtesy of CHRYSLER GROUP, LLC
Remove the rear input shaft rear bearing (1), spacer (2) and collar (3) using (special tool #P-334, Splitter, Bearing).

Fig 3: Forth Driven Gear, Thrust Washer & Blocker Ring
Courtesy of CHRYSLER GROUP, LLC
Remove the forth driven gear, thrust washer and blocker ring from the shaft.

Fig 4: Remove/Install Sleeve & Detents To Hub Assembly
Courtesy of CHRYSLER GROUP, LLC
Remove the slider ring and spring loaded detents from the hub.

Fig 5: Removing Hub & Third Gear From Shaft
Courtesy of CHRYSLER GROUP, LLC
Remove the hub and the third gear from the shaft using (special tool #P-334, Splitter, Bearing).

Fig 6: Needle Bearing
Courtesy of CHRYSLER GROUP, LLC
Remove the needle bearing (1).