LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 c Pop, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (1.4L 16-Valve Turbo Engine (Service Information) 500) >> Lubrication >> Pan, Oil >> Removal >> With Automatic Transmission

With Automatic Transmission

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine and transmission from the vehicle. Refer to REMOVAL .
  2. Remove the transmission from the engine. Refer to appropriate Transmission Service Information article.
    Fig 1: Starter Assembly, Connector & Fasteners
    GC0153134Courtesy of CHRYSLER GROUP, LLC
  3. Remove the starter assembly (5). Refer to STARTER, REMOVAL .
  4. Remove the flexplate. Refer to FLEXPLATE, REMOVAL .
    Fig 2: Transmission Adapter Plate & Fasteners
    GC0152425Courtesy of CHRYSLER GROUP, LLC
  5. Remove three bolts (3 and 4), one bolt and nut (2) and the transmission adapter plate (1).
  6. Drain the engine oil. Refer to STANDARD PROCEDURE .
    Fig 3: Oil Pan Flange Fasteners
    GC0152688Courtesy of CHRYSLER GROUP, LLC
  7. Remove fourteen bolts (1) and two nuts (2) from the flange of the oil pan.
  8. Using the four indicated pry points, carefully remove the oil pan.
  9. Remove all residual sealant from the oil pan, engine block, oil pump and rear seal retainer. Refer to CLEANING .
    Fig 4: Oil Pan Sealant Locations
    GC0152689Courtesy of CHRYSLER GROUP, LLC
  10. Remove all residual sealant (1) from the oil pan, engine block, oil pump and rear seal retainer. Refer to CLEANING .
scientia non olet · About LEMON Manuals