Insulator, Engine Mount, Right: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Air Cleaner Assembly, Intake Hose, Fittings & Clamp

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Remove the air cleaner body (1). Refer to BODY, AIR CLEANER, REMOVAL .

Fig 2: Lower Air Dam/Belly Pan
Courtesy of CHRYSLER GROUP, LLC
Raise and support the vehicle. Refer to HOISTING .
Remove the belly pan. Refer to BELLY PAN, REMOVAL .
Drain the cooling system. Refer to STANDARD PROCEDURE .

Fig 3: Tunnel Support Brace & Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove four bolts (1) and the tunnel support brace (2).

Fig 4: Pressurized Coolant Bottle, Reservoir Hose & Coolant Reservoir Bolts
Courtesy of CHRYSLER GROUP, LLC
Lower the vehicle.
Disconnect the coolant hose (3) from the pressurized coolant bottle (1).
Remove the two bolts (5) and reposition the pressurized coolant bottle (1).

Fig 5: RH Engine Mount Isolator, Support Bracket & Bolts
Courtesy of CHRYSLER GROUP, LLC
Support the engine with a floor jack positioned under the oil pan.
Remove six bolts (1 and 3) and the right engine mount isolator (4).