LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 c Pop, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (1.4L 16-Valve Turbo Engine (Service Information) 500) >> Engine Mounting >> Insulator, Engine Mount, Rear >> Removal >> Automatic Transmission

Automatic Transmission

WARNING: This page is about a different variant/trim than selected.
Fig 1: Lower Air Dam/Belly Pan
GC0082359Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle. Refer to HOISTING .
  2. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
    Fig 2: Tunnel Support Brace & Bolts
    GC0152449Courtesy of CHRYSLER GROUP, LLC
  3. Remove four bolts (1) and the tunnel support brace (2).
    Fig 3: Two Bolts Of Lower Transmission Mount
    GC0152406Courtesy of CHRYSLER GROUP, LLC
  4. Remove two bolts (4) from the rear engine mount bracket (3).
  5. Remove the bolt (1) and remove the rear engine mount isolator (5).
  6. If required, remove the two bolts (2) and the rear engine mount bracket (3).
scientia non olet · About LEMON Manuals