LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 c Pop, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (1.4L 16-Valve Turbo Engine (Service Information) 500) >> Engine Block >> Rod, Piston And Connecting >> Standard Procedure >> Connecting Rod Side Clearance >> Feeler Gauge

Feeler Gauge

WARNING: This page is about a different variant/trim than selected.
Fig 1: Connecting Rod Side Clearance
GC0121442Courtesy of CHRYSLER GROUP, LLC
NOTE:

Typical four cylinder engine shown in illustration.

  1. Slide a snug-fitting feeler gauge between the connecting rod and crankshaft journal flange. Compare the measured side clearance to the specification Refer to ENGINE SPECIFICATIONS .
  2. Repeat this procedure for each connecting rod. Rotate the crankshaft for connecting rod accessibility.
scientia non olet · About LEMON Manuals