LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 c Pop, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Emissions Control - 500) >> Evaporative Emissions - 1.4L 16-Valve Turbo (EAF) >> Sensor, Fuel Tank Pressure >> Removal >> Removal

Sensor, Fuel Tank Pressure: Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the fuel filler cap to relieve tank pressure.
  3. Partially raise the vehicle.
  4. Remove the right rear wheel house splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .
    Fig 1: Fuel Tank Pressure Sensor Electrical Connector
    GC0145298Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the fuel tank pressure sensor harness connector (1).
    Fig 2: Removing Fuel Tank Pressure Sensor
    GC0145299Courtesy of CHRYSLER GROUP, LLC
  6. Carefully raise the retaining tab (2), rotate and remove the fuel tank pressure sensor (1) from the fuel tank vent tube.
    Fig 3: Fuel Tank Pressure Sensor Seal
    GC0145300Courtesy of CHRYSLER GROUP, LLC
  7. The fuel tank pressure sensor seal (1) can be reused if not damaged.
scientia non olet · About LEMON Manuals