LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 c Pop, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Heating & Air Conditioning (Service Information) 500 - Except Electric) >> Plumbing >> Tube, Condensation Drain >> Removal >> Removal

Tube, Condensation Drain: Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

Fig 1: Condensate Drain Hose, Housing & Floor Panel
GC0152742Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the right side shifter housing trim panel. Refer to COVER, INSTRUMENT PANEL, REMOVAL .
  3. Disconnect the condensate drain tube (1) from the HVAC housing (3).
  4. Removed the condensate drain tube from the floor panel (2).