LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 c Pop, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Heating & Air Conditioning (Service Information) 500 - Except Electric) >> Controls >> Transducer, A/C Pressure >> Installation >> Installation

Transducer, A/C Pressure: Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Liquid Line Fitting O-Ring
GC0152397Courtesy of CHRYSLER GROUP, LLC
  1. Lubricate a new rubber O-ring seal (1) with clean refrigerant oil and install it onto the A/C liquid line fitting (2).
    Fig 2: Liquid Line, A/C Pressure Transducer & Connector
    GC0152396Courtesy of CHRYSLER GROUP, LLC
  2. Install the A/C pressure transducer (2) onto the A/C liquid line (3). Tighten the A/C pressure transducer to 5.1 N.m (45 in. lbs.).
  3. Connect the wire harness connector (1) to the A/C pressure transducer.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals