LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 c Pop, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (1.4L 16-Valve Turbo Engine (Service Information) 500) >> Air Intake System >> Body, Air Cleaner >> Installation >> Installation

Body, Air Cleaner: Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Air Cleaner Body, Air Make-Up Hose & Ball Stud Mounts
GC0157697Courtesy of CHRYSLER GROUP, LLC
  1. Lubricate the rubber mount sockets on the air cleaner body (1) with Mopar® Rubber Bushing Installation Lube.
  2. Install the fresh air make-up hose (2) to the oil separator housing.
  3. Align the air cleaner body (1) and press down onto the four ball stud mounts (3) to engage the rubber mount sockets.
    Fig 2: Removing/Installing Air Cleaner Body
    GC0157854Courtesy of CHRYSLER GROUP, LLC
  4. Install the air inlet hose retaining bolt (4) and tighten to 9 N.m (80 in. lbs.).
  5. Install the turbocharger inlet duct (1) to the hose and tighten the clamp (6) to 4 N.m (35 in. lbs.).
  6. Connect the EVAP hose quick release fitting (2) to the turbocharger inlet duct (1).
  7. Connect the wastegate solenoid vent hose (3) to the turbocharger inlet duct (1).
scientia non olet · About LEMON Manuals