LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 c Easy, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (Body - Interior & Exterior - 500 - Electric) >> Seats >> Seat, Front >> Removal >> Removal

Seat, Front: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: Floor Bolts
GC0153151Courtesy of CHRYSLER GROUP, LLC
WARNING:

On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

NOTE:

Base model shown, other models typical unless noted.

NOTE:

Driver side shown, passenger side typical unless noted.

  1. On vehicles equipped with the high voltage system, power down the 12 volt system. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
  2. Disconnect the negative 12-volt battery cable.
  3. Position the seat forward.
  4. Remove the seat to floor bolts (1, 2) located in the rear area of the front seat.
    Fig 2: Harness Cover & Retaining Pins
    GC0153154Courtesy of CHRYSLER GROUP, LLC
  5. Passenger side seats, remove the harness cover (2) by pulling the retaining pins (1).
    Fig 3: Floor Bolts
    GC0153150Courtesy of CHRYSLER GROUP, LLC
  6. Position the seat rearward.
  7. Remove the seat to floor bolts (1).
  8. Disconnect the wiring harness connectors.
    Fig 4: Seat
    GC0153147Courtesy of CHRYSLER GROUP, LLC
  9. Remove the seat from the vehicle.
scientia non olet · About LEMON Manuals