Condenser, A/C: Removal: Removal
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.
- Disconnect and isolate the negative battery cable.
- Remove the engine trim cover.
- Recover the refrigerant from the refrigerant system. Refer to STANDARD PROCEDURE .
- Remove the front fascia.
- Remove the front bumper beam.
- Remove the two screws (2 and 6) that secure the upper air dam to the radiator.
- Remove the three screws (3 and 5) that secure the lower air dam to the radiator.
- Disengage the retaining tabs and remove the upper and lower air dams.
- Remove the bolt (4) that secures the A/C liquid line (1) and the A/C discharge line (2) to the A/C condenser tapping block (3).
- Disconnect the A/C liquid and discharge lines from the A/C condenser.
- Separate the A/C liquid line from the A/C discharge line and remove and discard the dual plain seals.
- Install plugs in, or tape over, the opened refrigerant line fittings and condenser ports.
- Remove the two bolts (1 and 5) that secure right end of the A/C condenser (4) to the radiator.
- Tip the right end of the A/C condenser slightly downward to disengage the two retaining tabs (2 and 3) that secure the left side of the A/C condenser to the radiator, and carefully remove the condenser.