LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 c Easy, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (1.4L 16-Valve Turbo Engine (Service Information) 500) >> Engine Mounting >> Bracket, Engine Mount, Right >> Installation >> Installation

Bracket, Engine Mount, Right: Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: RH Engine Mount Bracket & Bolts
GC0152463Courtesy of CHRYSLER GROUP, LLC
  1. Install the right engine mount bracket (1) with six bolts (2) tightened to 25 N.m (18 ft. lbs.).
    Fig 2: Upper Timing Belt Cover & Bolts
    GC0152466Courtesy of CHRYSLER GROUP, LLC
  2. Install the upper timing belt cover (1) with two bolts (2 and 3) tightened to 9 N.m (80 in. lbs.).
    Fig 3: Upper Timing Belt Cover, Evaporative Emissions Purge Hose, Coolant Pump Return Hose & Wastegate Solenoid Pressure Inlet Hose
    GC0155975Courtesy of CHRYSLER GROUP, LLC
  3. Engage the following retainers to the upper timing belt cover (1):
    • Wastegate solenoid pressure inlet hose (2).
    • After run coolant pump return hose (3).
    • Evaporative emissions purge hose (4).
    Fig 4: Wastegate Actuator Hose, Solenoid, Electrical Connector, Vacuum Supply Hose & Nut
    GC0156333Courtesy of CHRYSLER GROUP, LLC
  4. Position the turbocharger wastegate solenoid (4). Install the bolt (5) and tighten to 9 N.m (80 in. lbs.).
    Fig 5: RH Engine Mount Isolator, Support Bracket & Bolts With Tightening Sequence
    GC0153367Courtesy of CHRYSLER GROUP, LLC
  5. Install the right engine mount isolator (3) to the engine mount bracket with three bolts. Tighten the isolator to engine bracket bolts in the sequence shown in illustration to 60 N.m (44 ft. lbs.).
  6. Install the right engine mount isolator (3) to the body with three bolts (2). Tighten the isolator to body bolts (2) to 60 N.m (44 ft. lbs.).
  7. Remove the floor jack supporting the engine.
    Fig 6: Pressurized Coolant Bottle, Reservoir Hose & Coolant Reservoir Bolts
    GC0156417Courtesy of CHRYSLER GROUP, LLC
  8. Install the pressurized coolant bottle.

    Refer to BOTTLE, PRESSURIZED COOLANT, INSTALLATION .

  9. Install the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION .
  10. Connect the battery negative cable and tighten nut to 5 N.m (45 in. lbs.).
  11. Install the belly pan. Refer to BELLY PAN, INSTALLATION .
scientia non olet · About LEMON Manuals