LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 c Easy, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (1.4L 16-Valve Turbo Engine (Service Information) 500) >> Air Intake System >> Body, Air Cleaner >> Removal >> Removal

Body, Air Cleaner: Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Air Cleaner Body
GC0157854Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the wastegate solenoid vent hose (3) from the turbocharger inlet duct (1).
  2. Disconnect the EVAP hose quick release fitting (2) from the turbocharger inlet duct (1).

    Refer to FITTING, QUICK CONNECT .

  3. Loosen the clamp (6) at the turbocharger inlet duct (1) and remove the duct from the hose.
  4. Remove the bolt (4) from the air inlet hose.
    Fig 2: Air Cleaner Body, Air Make-Up Hose & Ball Stud Mounts
    GC0157697Courtesy of CHRYSLER GROUP, LLC
  5. Disengage four ball stud mounts (3) and lift the air cleaner body (1) off of the engine.
  6. Remove the fresh air make-up hose (2) from the oil separator housing and remove the air cleaner housing from the vehicle.
scientia non olet · About LEMON Manuals