Lever, Parking Brake: Installation: Installation
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
- Place the parking brake lever (6) on the floor pan and install mounting bolts (2). Tighten the bolts to 30 N.m (22 ft. lbs.).
- Install the rear parking brake cables into the equalizer (3) on the parking brake lever output cable.
- Connect the wiring harness connector (2) to the parking brake switch (6).
- Perform parking brake adjustment procedure.
- Install the center floor console. Refer to CONSOLE, FLOOR, INSTALLATION .
- Remove the blocks from the tires and wheel assemblies.
- Power up the vehicle. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
- Connect the battery negative cable to its post on the battery.