LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 c Easy, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Chime/Buzzer/Driver Assist (Service Information) 500 - Except Electric) >> Module, Park Assist >> Installation >> Installation

Module, Park Assist: Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Park Assist Module, Connectors & Fastener At Rear C-Pillar
GC0152722Courtesy of CHRYSLER GROUP, LLC
  1. Position the Park Assist Module (PAM) (4) to the right quarter inner panel near the base of the C-pillar.
  2. Engage the lower mounting tab of the PAM into the stamped pocket (3) in the right quarter inner panel.
  3. Install and tighten the screw (1) that secures the upper mounting tab of the PAM to the right quarter inner panel. Tighten the screw securely.
  4. Reconnect the two (with rear park assist) or three (with front and rear park assist) body wire harness connectors (2) to the PAM connector receptacles.
  5. Reinstall the trim onto the right quarter inner panel. Refer to PANEL, QUARTER TRIM, REAR, INSTALLATION .
  6. Reconnect the negative cable to the battery.
scientia non olet · About LEMON Manuals