Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
INITIALIZE THE ABS MODULE
NOTE:
Diagnose and repair any Powertrain Module (PCM), VIN or Communication DTCs before continuing with this diagnostic procedure.
- Perform any Technical Service Bulletins that may apply.
- With the scan tool, under "Miscellaneous Functions" perform the ABS Initialization routine.
- Turn ignition off to the lock position.
- Cycle the ignition from off to on.
- Wait ten seconds.
- With the scan tool, erase DTCs.
- Wait ten seconds.
- With the scan tool, read DTCs.
Does the DTC remain active?
Yes
- Replace the Anti-lock Brake System (ABS) Module in accordance with the service information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time.