Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK ELECTRIC VEHICLE CONTROL UNIT (EVCU) DTCs
1. Turn the ignition on.
2. With the scan tool, read DTCs in the EVCU.
  Are there any EVCU Stop Lamp Switch related DTCs present?
  
  Yes
  - Perform the appropriate diagnostic procedure. Refer to ELECTRIC VEHICLE CONTROL UNIT (EVCU) MODULE - DIAGNOSTIC CODE INDEX - 500 - ELECTRIC .
  No
  - Go To 2
STOP LAMP SWITCH OPERATION/ADJUSTMENT
1. Verify the stop lamps are operating correctly.
2. Turn the ignition off.
3. Check for any Technical Service Bulletins (TSBs) that may apply.
4. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the Stop Lamp Switch and the Electric Vehicle Control Unit (EVCU).
5. Perform the Stop Lamp Switch Adjustment procedure. Refer to SWITCH, STOP LAMP, INSTALLATION .
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
  No
  - Go To 3
(B135) BRAKE SIGNAL 1 CIRCUIT SHORT TO VOLTAGE
1. Disconnect the Electric Vehicle Control Unit (EVCU) C1 harness connector.
2. Disconnect the Stop Lamp Switch harness connector.
3. Measure the voltage between the (B135) Brake Signal 1 circuit and ground.
  Is the voltage below 0.5 volts?
  
  Yes
  - Go To 4
  No
  - Repair the (B135) Brake Signal 1 circuit for a short to voltage.
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
ANTI-LOCK BRAKE SYSTEM (ABS) MODULE
1. Replace the Stop Lamp Switch in accordance with the Service Information. Refer to SWITCH, STOP LAMP, REMOVAL .
2. Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
3. Start the engine.
4. Press and release the brake pedal.
5. With the scan tool, read the DTCs.
  Does the DTC remain active?
  
  Yes
  - Replace the Anti-lock Brake System (ABS) Module in accordance with the service information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
  No
  - Test Complete.
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .