Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN ACTIVE DTC
1. Perform any Service Bulletins that may apply.
2. Turn the ignition on.
3. With the scan tool, read ABS DTCs and record on the repair order.
4. With the scan tool, read and record Environmental Data (EV Data).
5. With the scan tool, erase ABS DTCs.
  WARNING:
  To avoid possible serious or fatal injury, check brake capability is available before road testing.
6. Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 15 and 35 km/h (9 and 22 mph).
7. Park the vehicle on level ground.
8. With the scan tool, read the ABS DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the ABS-INTERMITTENT CONDITION TEST. Refer to ABS INTERMITTENT CONDITION .
ANTI-LOCK BRAKE SYSTEM (ABS) MODULE
1. Turn the ignition off.
2. Replace the Dynamic Sensor in accordance with the Service Information. Refer to SENSOR, DYNAMICS, REMOVAL .
3. Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
4. Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 15 and 35 km/h (9 and 22 mph).
5. With the scan tool, With the scan tool, read ABS DTCs.
  Does the DTC remain active?
  
  Yes
  - Replace the Anti-lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time.