Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

REGENERATIVE BRAKE CONTROLLER (RBC)

The Regenerative Brake Controller (RBC) is reporting internal errors.
NOTE:
Before continuing, check the Regenerative Brake Controller (RBC) harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.
Perform any Technical Service Bulletins that may apply.
Were there any problems found?

Yes
- Repair as necessary.
- Perform the RBC VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Replace the Regenerative Brake Controller (RBC) in accordance with the Service Information.
- Perform the RBC VERIFICATION TEST. Refer to STANDARD PROCEDURE .