LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 41 (Heating & Air Conditioning (Service Information) 500 - Electric) >> Plumbing >> Oil, Refrigerant >> Standard Procedure >> Standard Procedure - Refrigerant Oil Level >> Compressor Oil Drain Procedure

Compressor Oil Drain Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION:

Be certain to adjust the refrigerant system oil level when replacing an A/C compressor. Failure to properly drain and measure the refrigerant oil from the A/C compressor can prevent the A/C system from operating as designed and cause serious compressor damage.

The A/C compressor is filled with refrigerant oil from the factory. Use the following procedure to drain and measure refrigerant oil from the A/C compressor.

  1. Drain all of the refrigerant oil from the original A/C compressor into a clean measured container.
  2. Drain all of the refrigerant oil from the new A/C compressor into a clean measured container.
  3. Refill the new A/C compressor with the same amount of POE refrigerant oil that was drained out of the original A/C compressor. Use only clean POE oil.
  4. Install the new A/C compressor onto the engine. Refer to COMPRESSOR, ELECTRIC AIR CONDITIONING (EAC), INSTALLATION .
scientia non olet · About LEMON Manuals