LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Electric Powertrain System - 500 - Electric) >> Power Electronics Cooling System >> Standard Procedure >> Power Electronics Coolant Draining

Power Electronics Coolant Draining

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle. Refer to STANDARD PROCEDURE .
  2. Remove the lower radiator air deflector.
  3. Position a suitable drain pan and open the power electronics coolant radiator drain cock. Allow the coolant to drain until it stops.
  4. Using suitable hose-pinching pliers, clamp-closed the coolant hose between the power electronics coolant radiator and onboard charging module.
  5. Using suitable hose-pinching pliers, clamp-closed the coolant hose between the power electronics coolant reservoir and the T-fitting near the power electronics coolant radiator lower hose connection.
  6. Connect a suitable cooling system pressure tester to the power electronics coolant reservoir.
  7. Pump the cooling system pressure repeatedly until the remaining coolant no longer drains from the power electronics coolant radiator drain cock.
  8. Close the power electronics coolant radiator drain cock.
  9. Remove the clamps from the coolant hoses, and disconnect the cooling system pressure tester.
scientia non olet · About LEMON Manuals