LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Power Windows (Service Information) 500 - Electric) >> Switch, Power Window >> Installation >> Installation

Switch, Power Window: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Window Switches, Retaining Tabs, Gear Shift Indicator Bezel & Harnesses
GC0152768Courtesy of CHRYSLER GROUP, LLC
  1. Position the switch (1) on the shifter bezel (3).
  2. Install, and tighten the fasteners securing the switch.
  3. Connect the electrical harness connectors (4) to the switches.
  4. Position the bezel assembly; aligning the clips (2) with the console, and press into place.
  5. Connect the 12 volt negative battery cable.
  6. Power up the high voltage system. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals