Prop, Gas: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Do not use any type of pliers on the machined surface of the gas prop to assist in supporting the hood or decklid. Use a proper device for support, or the help of an assistant.

Fig 1: Incorrect Way To Prop Hood

Courtesy of CHRYSLER GROUP, LLC

Open and support the liftgate with a suitable prop or block.

Fig 2: Support Cylinder Removal
Courtesy of CHRYSLER GROUP, LLC
Using a small flat bladed tool (3), or equivalent, release the retaining clip (2) while pulling the ball socket (1) away from the ball stud (4).

Fig 3: Gas Prop/Support Cylinder
Courtesy of CHRYSLER GROUP, LLC
Remove the gas prop/support cylinder (1).