Nozzle, Washer: Installation: Rear
WARNING: This page is about a different variant/trim than selected.
- Position the rear washer nozzle (2) to the liftgate outer panel. Be certain the orifice is pointed down toward the liftgate glass and the rubber seal is in place on the back of the nozzle.
- Connect the washer supply hose (1) to the barbed nipple on the back of the rear washer nozzle.
- Insert the rear washer nozzle supply hose and nipple into the mounting hole in the liftgate outer panel.
- Using hand pressure, press firmly and evenly on the hood of the rear washer nozzle until the latch features snap into place behind the sheet metal of the liftgate outer panel mounting hole.