LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 34 (Wiper System & Washer System (Service Information) 500 - Electric) >> Nozzle, Washer >> Installation >> Front

Nozzle, Washer: Installation: Front

WARNING: This page is about a different variant/trim than selected.
Fig 1: Cowl Plenum Cover/Grille Panel, Hose Connection, Barbed Nipple & Latch Features
GC0153304Courtesy of CHRYSLER GROUP, LLC
  1. Position the front washer nozzle to the mounting hole on the top of the cowl plenum cover/grille panel (3).
  2. Using hand pressure, push firmly and evenly on the top of the nozzle until the five integral latches (4) snap into place on the underside of the panel.
  3. From the underside of the cowl plenum cover/grille panel, connect the washer hose (1) to the barbed nipple (2) of the nozzle.
  4. Install the cowl plenum cover/grille panel onto the vehicle.
  5. Confirm proper front washer nozzle aiming. Refer to STANDARD PROCEDURE  .
scientia non olet · About LEMON Manuals