Lamp, Cargo: Removal: Bulb
WARNING: This page is about a different variant/trim than selected.
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- On vehicles equipped with the high voltage system, power down the 12 volt system. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
- Disconnect the negative 12 volt battery cable.
- Remove the cargo lamp from the vehicle. Refer to LAMP, CARGO, REMOVAL .
- Disengage the end of the lamp lens (3) with the latch feature from the retention pin on each side of the lamp hood (1).
- Pivot the lens up from over the hood.
- Unfold the lamp hood from the lamp socket (4) far enough to access the bulb (2).
- Pull the base of the bulb straight out of the socket.