Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read DTCs and record on the repair order.
  Is the DTC active or pending?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
VERIFY THAT THE BODY CONTROL MODULE IS CAPABLE OF SETTING AMBIENT AIR TEMPERATURE SENSOR FAULTS
1. Check the BCM fault code list to verify that the BCM has the capability to set DTCs against the AT Sensor. Refer to BODY CONTROL MODULE (BCM) - DIAGNOSTIC CODE INDEX - 500 - EXCEPT ELECTRIC .
  Are there any AT Sensor faults listed in the DTC list for the BCM?
  
  Yes
  - Go To 3
  No
  - Go To 4
CHECK THE BODY CONTROL MODULE FOR AT SENSOR FAULTS
1. With the scan tool, read DTCs in the BCM.
  Is the BCM setting any DTCs against the AT Sensor?
  
  Yes
  - Perform the diagnostic procedure in the BCM. Refer to BODY CONTROL MODULE (BCM) - DIAGNOSTIC CODE INDEX - 500 - EXCEPT ELECTRIC .
  No
  - Replace and program the Body Control Module in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
CHECK THE AT SENSOR WIRING
1. Turn the ignition off.
2. Disconnect the AT Sensor harness connector.
3. Disconnect the appropriate BCM harness connector.
4. Check the AT Sensor wires:
  - for an open condition.
  - for a short to voltage.
  - for a short to ground.
  - for a short to each other.
  Were any problems found with the wiring?
  
  Yes
  - Perform the appropriate repair of the wiring.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Go To 5
AT SENSOR
1. Replace the AT Sensor in accordance with the Service Information.
2. Reconnect all harness connectors.
3. Turn the ignition on.
4. With the scan tool, read DTCs and record on the repair order.
  Is the DTC still active?
  
  Yes
  - Replace and program the Body Control Module in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Repair is complete.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .